The "connector" parameter is used to define the types of processing pipes used in a Fluid Topics portal.
The "connector" parameter is mandatory during installation. Defining "connector" values enables the processing pipes for the portal. If unset, there will be no way to process data.
It is a list composed of one or more of the following values:
- "Dita": consult DITA Connector Configuration Guide.
- "Authorit": consult Author-it Connector Configuration Guide.
- "AuthoritMagellan": consult Author-it Connector Configuration Guide.
- "Ftml": consult FTML Connector Configuration Guide.
- "UnstructuredDocuments": consult Unstructured Documents Connector Configuration Guide.
- "MapAttachments": consult Map Attachments.
To request a format not listed above, contact the Fluid Topics Help Desk.
Example
{
"ui": {
...
},
"khub": {
...
"pafs": {
"connector": [
"Dita",
"Authorit",
"AuthoritMagellan",
"Ftml",
"UnstructuredDocuments",
"MapAttachments"
],
...
}
}
}
All connectors listed in the conf.json file trigger the creation of the corresponding PaFs, which are available in the Back Office.
The Default Author-it, Default UD, and Default DITA sources are automatically installed and available in Fluid Topics. It is possible to use these sources to publish content directly.
The Ftml source is not automatically created but Ftml is available in the Manage sources interface to create a source to process FTML content.